My question is, how important is the ASD relay? Can I cut the wire from the ECM and ground it out to make the relay work without detrimental effects? Seeing that one wire is from the ignition switch it would make sense that the wire from the ECM should be the ground. So out of the four terminals used on each relay, three of them currently receive power and because of this, no power is supplied to my fuel pump. The wire from the ignition supplies power to switch the relay on when the key is on and the wire from the ECM also supplies power to the relay. When the ignition switch is in either the START or RUN position, it connects circuit A1 from fuse 8 in the Power Distribution Center (PDC) to.1 answer Top answer: Hello, Message 4 out of 4I just thought you might want this for your information. It should be located under the hood on the left side of the engine as you are looking at it (on the right side technically) It is located with a Relay Box Power Distribution Center IPM. Tailgate Opening Lift Door to Body Seal Reproduction Jeep Cherokee. Fuel Tank Skid Plate Mounting Bolt 2-Pc.Lock Nut Set OEM Wrangler 1987-1995. Front Door Check Cherokee & Comanche 1984-2001 36.95. Headliner Upper Roof Trim Molding Rear Door Piece OEM Cherokee 1984-2001 29.95 12.95. The circuit has one wire from the ignition switch to the ASD and fuel pump relays and one wire from the ECM to the ASD and fuel pump relays. Re: Where is the automatic shutdown relay on my 1996 jeep. Micro Relay OEM Cherokee 1993-1996 15.89 3.50. I've studied the diagram and traced the wires and can't seem to figure this one out. Gasoline 1997-1998: Automatic Shut Down Relay, Radiator Fan Relay, Fuel Pump Relay, Air Conditioner Compressor Clutch Relay, Back-Up Lamp (Back-Up Lamp Switch (M/T), Transmission Range Sensor (A/T)), Transmission Control Module, Duty Cycle EVAP/Purge Solenoid, EVAP Leak Detection Pump, Daytime Running Lamp Module, Torque Converter Solenoid. I'm having some issues with my relay wiring.
0 kommentar(er)
